The VLTOR EMOD provides a variety of enhancements in comparison to other stocks. The increased length is a major benefit for those weapons using scoped rifles, as it increases the available comb for any length of pull. The EMOD is slightly wider and longer at the toe than a regular M4 stock with a noticeable negative pitch making transitions from the ready position feel more natural.
Waterproof side battery compartments that holds 4 CR123 or three AA batteries in each compartment
Weatherproof compartment in the clubfoot area of the stock that hold two AA batteries
Comes pre-assembled with rubber buttpad and strike plate
Matte (anti-reflection/anti-glare) finish
Impact and temperature resistant polymer, specifically blended for VLTOR stocks
Has standard military and quick disconnect swivel socket accessible from both sides
Slightly wider and longer at the toe than a regular M4 stock with a noticeable negative pitch making transitions from the ready position feel more natural
Kit includes five position Mil-Spec receiver extension , carbine spring and buffer kit, VLTOR Lock Plate and VLTOR Lock Nut
Length with buttpad: 7.75 inches (at centerline of tube)
Weight: 14 oz
LOP fully collapsed: 11.50 inches
LOP fully extended: 15.00 inches
Buttpad angle: -5 degrees with decrease to -15 at toe
Receiver extension is made of 7075 T6 impact extrusion
REVIEWS
***** Chose over Magpul Review by Owen
It arrived several days later, all in good condition. I installed the stock onto a Colt LE 6940P. It does fit rather snugly on the factory buffer tube, but I’d rather that over a loose fit for sure and with some dry lubricant it slides just fine. The battery storage is terrific and perhaps the best I’ve seen on a stock. My cheek placement/eye relief on the rifle is just great with the profiled stock and without having more of a sniper-type fixture for a cheek pad, again, this is by far the best I’ve used. I also married the stock with grips from Stark and the color match is darn near identical. My first 30 rounds out of the newly set up weapon netted a grouping inside 1.5? at 100yds. So obviously it feels just right.
All in all, I couldn’t be happier; between the cost, fit, finish and support on the purchase it was an excellent choice.
***** Review by tcash
I have one on a LWRC M6A3 and just bought one to put on a new AR build. I use it in multi-gun competition and it’s perfect for quick transitions. The big plus that it has is the shape that provides for an excellent cheek weld…wonderful and steady. I always have need for batteries as my red dot is constantly on, and it’s quite easy knowing that they are always in the on-board storage along with a few critical spare parts. A little tissue, nitrile gloves, or plastic baggies come in handy while keeping things from rattling. Stock finish is top notch and the built-in QD works easily and flawlessly.
Shopping
CartItems0
