BATTLEARMS EKG AK Trigger Kit BAD Enhanced AK47 AK-47

BATTLEARMS EKG AK Trigger Kit BAD Enhanced AK47 AK-47

New from Battle Arms Development (BAD)!

BAD-EKG... Powering the Kalashnikov heart within you.

Features:

• Maximum compatibility with most standard production AK patterned firearms.
• Enhanced hammer geometry to eliminate that "hump" feel when charging the AK, to give you that smooth custom feel.
• Thru-harden steel (no softcore) HRC 42-45.
• Due to proper heat treat, this minimizes internal wear or mushrooming the back of the carrier from over hardened hammers.
• Two raised dimples on the back to allow for an easy index of hammer spring.
• Made in the USA for 922r compliance  3 Pieces (Hammer, Trigger, Disconnector).
• Comfortable trigger shoe.
• Distinctive trigger bow design.
• Clean crisp break (compare to standard mil-spec).
• Short, smooth, and positive reset
• No Trigger Slap.
• Single Hook Design.
• Black Phosphate Finish.

What is included:

1. Hammer
2. Trigger
3. Disconnector
4. Disconnector spring
5. Axis pin sleeve

Note: Does NOT come with trigger or hammer springs. Users will need to purchase springs separately from another vendor.

Application: Stamped AK47 and AK74 variants. May work in additional variants, however, BATTLEARMS® cannot guarantee proper fit and function in other platforms. These triggers may require fitment to work properly in other platforms. Please read BATTLEARMS® Return Policy for more information. Any modified triggers cannot be refunded or exchanged. We advise contacting us with questions prior to any modifications for fitment questions.

REVIEWS

5 STAR RATED R Parker Published on September 22nd 2021, 10:51:23 am

Wanted improvement over Tapco G2. Not disappointed. No its not a range queen trigger. Great hunting and tactical trigger. Slight travel then a light wall with a crisp 3.5 to 4 lbs break. Short audible reset. Best of all, no binding on the bolt at the halfway point. The guys at Battle Arms are great, more than willing to talk to you. Before I installed mine I lightly polished it. No grinding, just a Dremel with a fine wire wheel to remove coating off contact points then a cotton wheel with some polishing compound. Very pleased !